Maytag French Door Refrigerator Ice Maker Not Working

Verify that the ice maker is turned on.

Maytag french door refrigerator ice maker not working.

Next fill up the icemaker with a cup of water and wait 24 hours to see if it cycles and dumps the ice. First make sure the freezer is below 10 degrees because the icemaker will not cycle if the temperature in the freezer is over 10 degrees. Check for clumping near the ice ejector arm or auger. If the ice maker s water supply is not connected to water supply line turn the ice maker off.

A clogged or incorrectly installed water filter will reduce the water flow to the ice maker and dispenser which will result in small ice cubes low ice production or decreased water flow. If the door switch does not have continuity when activated replace it. Unjam the ice maker chute. Flushing the water system forces air from the water line after the refrigerator has been installed or the water filter has been replaced.

The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly. If the ice maker is on but disconnected to water supply line the following could happen. If the control board is faulty it may stop supplying power to the entire dispenser system. Not producing ice at.

Freezer temperature is above 10 degrees f 12c if the freezer temperature is above 10 degrees fahrenheit 12c the ice maker will not produce ice cubes efficiently. Repeat until water begins to flow. To determine if the door switch is defective use a multimeter to test it for continuity. Check that the ice cubes are not jammed in the chute.

Flush the water system. Test the ice maker dispenser about one hour after removing all the jammed ice cubes. Fix a maytag french door refrigerator that has this following issues. If the door switch fails the dispenser will not turn on.

The door switch turns off the ice and water dispenser when the refrigerator door is open. The ice maker will continue to try to make ice causing a buzzing sound. If the refrigerator has a water dispenser check for a problem with the filter by doing the following. Use a sturdy container to press and hold the water dispenser pad for 5 seconds then release it for 5 seconds.